Service Packs

Download Service Pack/Hotfix

We recommend users to move to the latest version, Vulnerability Manager Plus build #11.2.2335.11 (Learn what's new!)

The SHA256 checksum hash value is 1a5d97461d90ae11496fa69bc7180dfb007d5791d1c4e21048cc9702e9641b06 Learn more

For steps to install the service packs, click here.

  • If your build number isUpgrade to Build NumberSHA256 Checksum hash value
  • 10.0.325 to 10.0.716Download and upgrade to 10.1.2119.10 .CE67AABDCBFDFBFF6CC6069A535E73D92AF35AEE119629977A4AE226782A2879
  • 10.1.2119.10 to 11.1.2246.01Download and upgrade to 11.2.2300.27 .82A83D63EADAE2B53E93F50EAF7D90B3DE1B66C3B296E782F766B321BA379616
  • 11.1.2300.01 to 11.2.2335.10Download and upgrade to 11.2.2335.11 .1a5d97461d90ae11496fa69bc7180dfb007d5791d1c4e21048cc9702e9641b06

You can find the build number at the top right side corner of Vulnerability Manager Plus product.

Instructions to Apply Service Packs/Hot Fixes

  1. Shut down Vulnerability Manager Plus i.e. right click the Vulnerability Manager Plus logo on the Notification area of Task bar and click on Stop service)
  2. Important:
    • If you have to install a couple of service packs and hotfixes to reach the latest version, it is recommended to exit the Update Manager tool for every PPM installation.
  3. Execute the UpdateManager.bat file present in the/VulnerabilityManagerPlus/bin directory.
  4. Click "Browse" and select the.ppm file that you have downloaded.
  5. Click "Install" to install the service pack. This may take few minutes depending on the amount of data that needs to be migrated.
  6. Wait until the service pack / hotfix is fully installed.
  7. Click "Close" and then click "Exit" to exit the Update Manager tool.
  8. Start the Vulnerability Manager Plus.

How do I find out my build number?

You can find the build number at the top right side corner of Vulnerability Manager Plus product.

What is a Failover Server setup?

A Failover server is a secondary server that starts managing your devices if the primary server goes down, thus eliminating any downtime caused. Learn more.

How to check whether you have a Failover Server setup or not?

In the Vulnerability Manager Plus's web console, go to the Admin tab, under Server Settings, click Failover Server.

If you do not have a Failover Server setup, then the page will look similar to the image given below:

If you do have a Failover Server setup, then the page will look similar to the image given below:

Depending upon the type of setup you have, please follow the instructions below.

Steps to follow if you do not have a Failover Server setup

Steps to follow if you have a Failover Server setup